DANHEAT has a wide rage of boilers
Steam Generator CONDOR RAPID
Steam Generator CONDOR RAPID CONDOR RAPID is designed so that it is steam tubes forming the boiler wall. The boiler has almost no vapor volume and is therefore not subject quite as strict rules as steam boilers. The steam generator is installed with an oil or gas burner, and due to the very small amount of water, there is a very short time from a cold start of the vapor pressure is present.CONDOR RAPID comes in either vertical or horizontal version so it can fit local conditions. CONDOR RAPID and characterized - High reliability by
CONDOR RAPID comes in either vertical or horizontal version so it can fit local conditions. CONDOR RAPID and characterized - High reliability by
CONDOR RAPID and characterized - High reliability by proper reconciliation of boiler components. - Can operate with the feed water temperature up to 105 gr.C. - Provides a very "dry" steam due to the careful tuning of pump performance.
The steam generator is provided with valves start to internally circulate until the vapor pressure has been reached. - Execution as 3 pass boiler and preheating the combustion air provides an efficiency of up to 91%. - Easy maintenance.
All pressure parts are performed in accordance with PED 97/23 / CE norm. And quality assurance includes X-ray photography of all boiler welds.
Dampkedel CONDOR AUTOMAT
CONDOR AUTOMAT is a three pass boiler where all boiler tubes is below the boiler min. water level . The powerful boiler tubes are dimensioned with such a surface , the boiler can achieve optimum efficiency without the use of turbulators on
flue gas .
This implies that there is a low thermal load on the heating surfaces of the boiler , the boiler and therefore suitable both at constant and varied the steam load.
CONDOR AUTOMAT 's characteristics :
• All boiler tubes under my . water level
• Over sizing of the boiler heating surfaces
• Low thermal load
• Excellent fuel economy in both liquid and gaseous fuels
• No turbulators therefore easy maintenance
All pressure parts of the boiler is performed in accordance with PED 97/23 / CEE and quality assurance includes X-ray photography of the boiler welded joints.
Cylindrical design in certified steel plates.
Powerful insulation with piston insulation, easy to open for inspection of firebox and convection pipe.
High quality steel pipes - all pipes are welded on the front and rear manifold of the boiler.
Alle transistions are manually drilled in the steel plate to avoid craskings in the steel.
All boiler connections are made with welded flanges.
Boiler body is insulated with 70 mm mineral wool and exterior coated with powder coated steel plates.
The boiler is supplied on a steel foundation for easy installation
Hot Water Boiler MITOMAX
MITOMAX is a highly efficient three pass boiler fire tube boiler .
The boiler is designed with a large front door , providing easy access for cleaning and maintenance.
The boiler front door can be installed for opening to the right or left.
The boiler is supplied with standard panel for two-stage burner, other controllers are available customized .
The boiler design eliminates the use of the bypass pump .
Measurements MITOMAX 1500-2700
(420-530) DN 100/PN 6
(620-750) DN 125/PN 6
(1000-1250) DN 150/PN 6
(1500-2200) DN 150/PN 16
(2700) DN 200/PN 16
3 Smoke gas outlet
4 Cleaning door
5 Smoke gas connects cleaning door R1"
6 Outlet R 1½"
7 Wire connection
8 Control panel
9 Electrical connection
10 Fitting Rp ¾" with pocket for burner temp.sensor